6 Tips for Aluminum Plate Ceiling

Date: 2021-08-19 23:16    Hits: 1235

There are many functions of aluminum composite panels. Such products are often used in the decoration of the home, especially in the ceiling. There are 6 tips to use aluminum composite panel for the ceiling.

 


 

1. Do not tear off the protective film of the aluminum plate

For the new aluminum ceiling, there is a protective film on its surface, so before installation, we first need to calculate the installation area of ​​the aluminum ceiling and how much film will be torn off.

The remaining aluminum ceiling without breaking the film can be returned, so you must pay attention to this. Don’t tear off all the aluminum ceiling films at once, otherwise it will not be refundable and you can only pay for it yourself.

2. The film of the aluminum ceiling must be removed before installation

In some houses, the homeowners did not attend classes during the renovation process, nor did they tear off the film before installing the aluminum ceiling. However, after installation, they remember to tear off the film evenly, but the film is not easy to tear off at this time. Some will remain, and if excessive force is applied, it will also cause deformation of the aluminum ceiling.

3. Make a mark on the water circuit

Because this will involve a stamping process, the walls must be marked after completing the waterway and waterway works. In this way, we can avoid these places when punching holes, otherwise, when the time is up, once a hole is punched in the wire and water pipe, it will be very troublesome in the future.

4. The problem of hollow bricks must be avoided

This is still related to drilling. If the tiles on the wall are hollow, it is easy to damage the tiles in the later drilling process. Therefore, before the aluminum ceiling is made, the tiles must be inspected and accepted.

5. Punching depth

The drilling depth is 3-4 cm. In addition to avoiding hitting the pipe, it is also necessary to avoid damaging the waterproof layer. Therefore, the depth of the hole should not be too deep (3-4 cm).

6. Design the location of the lighting vents in advance

In order to avoid future troubles, before installing the aluminum ceiling, you must design the lighting vents and the installation location of the kitchen radiator.

 

Post a comment

Comments:
Name: Verification code:  9160